Safety

Keep the tow ball clean and free of grease.

Check the bike carrier before use if there is any damage. Damaged or worn parts need to be replaced immediately. Only use original replacement parts.

Do not make any modifications on the bike carrier (mechanical or electronic) This can be very dangerous. Warranty claims will not be accepted and we can not guarantee the correct functionality of the bike carrier, if you done modifications. We are not responsible for damage caused as result of incorrect assembly, installation or modification.

Check the correct operation of the lighting at regularly.

Always make sure that the bikes are firmly fixed by using the belts.

Always use the extra safety belt, for extra protection of your bikes. Run the safety belt trough the U-frame and the frames of the bikes, and pull this firmly.

Make sure that no parts of the bike can get lost during driving (battery, pump, basket, saddlebags, etc.). Always remove these before driving!

Check regularly if all the belts, knobs and fixations are firmly secured and if necessary secure them again.

Do not cover the bikes with a cover while driving.

Driving with a bike carrier affects the performance of your car. Adjust your speed accordingly (max 120km/h). Try to avoid sudden braking and steering movements.

Please remember when driving in reverse that the car is longer than usual!

In addition, pay attention to the regulatory requirements applicable to the transport of goods at the back of your vehicle.

When you have a vehicle with electronic parking sensors, an error message can come when the bike carrier is mounted. Switch off the parking system during the use of the bike carrier.

If the car is equipped with an automatic opening of the trunk, this must be switched off or only opened manually, if the bike carrier is mounted.

Take the bike carrier of the tow ball before using the carwash.

The bike carrier is not suitable for “off road” use.

Take the bike carrier of the tow ball if not used.

After use, the carrier can be easily stored in the boot of your car or at home, in the shed or garage. A practical carrier bag is supplied with the bike carrier, so everything can be stored away neatly.

In case of defects or problems please contact us.

Maintenance

Always store the bike carrier clean and dry after use. If necessary clean with fresh water to remove mud and other dirt.

Keep the tow ball of the car clean and free of grease.

Keep the connector of the bike carrier clean and free of grease.

Check the bike carrier regularly if there is any damage. Damaged or worn parts need to be replaced immediately. Use only original replacement parts.

The nuts and bolts of the bike carrier need to be checked regularly, if necessary tighten them again.

If there is a damage on the powder coating of the bike carrier this needs to be treated with paint immediately to avoid rusting.

Rotating and moving parts need to be oiled regularly.